Courtesy of: |
PLACEMENT GUIDELINES |
PLACEMENT GUIDELINESThe placement of a design on a garment is subject to many variables such as customer preference, the size and style of the garment, the size and style of the design and the degree of difficulty in working with the garment. We have assembled some guidelines for placing designs on the most popular garments. Please note that these measurements are approximate and refer to the center point of the entire design. If in doubt, mark one garment, then physically put the garment on a person to check location. | |
Golf Shirts | 7-1/2" to 9" down from the left shoulder seam and 4" to 6" over from center - in line with neck meeting shoulder seam. |
T-Shirts | >7-1/2" to 9" down from the left shoulder seam and 4" to 6" over from center |
Jackets | Left Breast Area: 3-1/2" to 4" over from the center edge and 6" to 8" down from the shoulder seam - Snap jackets - 2nd snap location |
Full Fronts | Depends on size of garmnet - Center of design should be high enough on the garment to ensure that no part of the design falls below the botto of the "arm it" - Top of design 3" below neck band. |
Full Backs | Top of deisn - 5" down from base of neck - large designs OK to ho below arm pits. Garments with hoods - designs must be placed lower to clear hood. |
Wash Cloths | 1-1/2" above hem or 1" above border |
Hand Towels | 2" above hem or 1-1/2" above border |
Bath Towels | 4" above hem or 2" above border |
Sheets | The bottom of the monogram should be centered about 2" above the wide hem line on the top side of the sheet |
Pillow Cases | The monogram should be centered between the edge of the open end and the stitching on the hem or the border pattern |
Shirt Pockets | Top design 1/4" to 1/2" down from the pocket edge and centered between the seams. |
Shirt Cuffs | 1-3/8" toward the button hole (from center) and 1/4" above the top stitching at edge |
Ties | 2" to 2 1/2" up from the collar and centered on front |
Turtle Necks | Left neck area centered between center front and left shoulder seam. Bottom of design 1/2" to 3/4" up from edge |